|10-06-2016, 12:14 AM||#1|
Join Date: Sep 2016
CA M14 Power Issue
So I received the M14 Match that I bought from another forum member and firstly replaced the connectors for Deans to allow me to use my batteries.
Plugged in a battery (Not fully charged) and went to shoot a few rounds to make sure everything was working as it should.
A couple of round probably only travelled about 5m in a very downward curve. (Not hob affected, just severe lack of power).
Most of the rounds however did manage to get to the back of my garden, but at a much slower pace than what I would have expected.
Plan is to do a complete strip down of the rifle and clean all components and maybe a spot of silicone grease on the gears.
Has anyone experience a similar situation with little power? Anything specific I can look at or look to replace?
Long term, I want to convert into a DMR, so will be upgrading spring, gears and motor to give a consistent 450fps MAX.
(Does anyone know what the stock gear ratio is?)
Any advice on the above issue would be much appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|VSR 10 - Edgi Cylinder Head + Maple Leaf Bucking Issue||Homie||VSR Rifles||15||09-20-2016 10:26 PM|
|VSR 10 - Edgi Cylinder Head + Maple Leaf Bucking Issue||Homie||VSR Rifles||0||09-17-2016 02:56 PM|
|Vsr 10 feeding issue||loudeli||VSR Rifles||9||09-10-2016 09:55 PM|
|VSR 10 range issue||loudeli||VSR Rifles||6||08-23-2016 12:04 PM|
|BAR-10 Magazine Well Issue||Bumbo||VSR Rifles||14||08-18-2016 01:45 PM|