Airsoft Sniper Forum banner

ASG Ashbury Upgrade Guide

8K views 21 replies 12 participants last post by  BxTan 
#1 · (Edited)
#4 ·
Very nice man!! +1 from me!

And I was correct, the feed system is a direct copy from the TM L96 rifle.

Not a bad system, but to work on the rifle in any way you have to take the entire thing apart just to get to anything. This can get tiresome especially with all of the little screws that you have to remove, you have a very good chance at stripping those little screw holes, as well as cross threading them.

I with they would come up with a better way of attaching the feed ramp and what not. Would be nice to see posts, and little cotter pins ( much like you would see on an RC car to hold the body to the frame.


Over all it does look like one bad @@@ rifle. And as much as I would love to have one, I am sure I will not have the funds anytime soon.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top