Nozzle-to-bucking seating

Rubiksklube · Feb 3, 2014

MEGA NECRO.
I'm about to sell my damn M4 and dump all my money into my VSR. I keep getting damn frustrated. Don't know if my volume is balance right, hop up seems wack, compression is not all the way there, etc.

I would like a list of what people use with success in terms of their buckings and nozzles.
I am planning on using a Guarder M4 nozzle. What buckings do you guys use these with? Or what nozzle and bucking do you guys use that mesh well together? Right now I'm averaging ~320 with an M120. I'm using a Bravo nozzle with a Modify o-ring. And a Madbull bucking. The bravo nozzle is way too wide. I might lathe it down if I can figure out how to....

By the way, I wanted to make sure this should be my goal when it comes to the seating of the BB and nozzle. Shouldn't the nozzle be just in the lips and the BB pinned between the nub?

Hammar · Feb 4, 2014

http://www.airsoftsniperforum.com/43-longrange-aegs/3843-nozzle-designs-what-s-your-take.html

Here is how i do it, massive difference, but tricky to get right the 1st time.

Rubiksklube · Feb 4, 2014

How did you do it?

chiba · Feb 25, 2014

Have you tried the Lonex Air Nozzles?

They have two: One for M4, and one for CAR-15.

I have a G&P gearbox and C7 upper/lower receiver for the M4. Surprisingly the M4 air nozzle was too long and the CAR-15 was perfect.

Nozzle-to-bucking seating

Rubiksklube

Attachments

Hammar

Rubiksklube

chiba

Top Contributors this Month

Recommended Communities