Airsoft Sniper Forum banner
1 - 7 of 7 Posts

hidden187

· Registered
Joined
·
445 Posts
Discussion starter · #1 ·
Has anyone had a chance to try out Angles customs? Check out the link its parts that look like laylax and PDI, I wanted to see as I am going to make a new L96 and may try these if anyone else has.

Evike.com
 
Discussion starter · #3 ·
Yeah, there was a thread about Angel's customs recently. I can't find the thread so it may have been on another forum. :p
XD Well thats a lot of nothing, thanks I looked on here and didn't see it so I thought I try. :)
 
Yeah their VSR parts are not to bad...have use a few of their parts for some builds. I would assume that their APS-2 parts would be up to the same standard.

Give them a try and let us know how they go.
 
I used their aps-2 piston and piston cup, spring guide, and spring in my M99 with great results; consistency +-1 fps with some diy mods. But some people claim otherwise, so thats just my .02

Edit: Their springs are notorious for dropping well below their rated power. But you if you buy a higher rated spring then send a good number of round through it, it will be settled and be very consistent. I bought an SP210 (Rated at something like 600 fps by Angel Customs) knowing this, and after some tuning and sending a bunch of rounds through the gun, I get right about 380 FPS with .43
 
1 - 7 of 7 Posts