Airsoft Sniper Forum

Airsoft Sniper Forum (https://www.airsoftsniperforum.com/index.php)
-   AWS/AW338 (https://www.airsoftsniperforum.com/forumdisplay.php?f=58)
-   -   New to forum + feeding problem with TM clone (https://www.airsoftsniperforum.com/showthread.php?t=28274)

CrazyCat109 01-16-2017 07:31 PM

New to forum + feeding problem with TM clone
 
Hi all, names mitch and im new to the forum. Think i posted this in the wrong section but cant find how to delete it. Anyway i have a well mb4402 (tm clone) with a feeding issue when trying to use bbs over .25g. When i am pushing the bolt forward the bb gets jammed about 3/4 the way through what i am assuming is the loading ramp. I have replaced the ramp with a genuine TM ramp and replaced the loading plate with the airsoftpro alloy version. But still the fault is present. I am using .40g blaster devil bbs. I also have baws .25g which feed fine. Any ideas? I was thinking replacing hop up chamber.

kristian_aws 04-12-2017 10:19 AM

Try with different brand of BB, also happend to me with madbull gray 0.40 bbs, but with Top Arms .40 and .43 they feed fine without any jam, it has to be something with the surface of the bbs, that they get stuck in the ramp wile the fin pushes it, or you can just try to feed the bb pointing the barrel downward a bit, it helps but will not fix the problem.

indycar 05-28-2017 07:12 PM

Quote:

Originally Posted by CrazyCat109 (Post 248282)
Hi all, names mitch and im new to the forum. Think i posted this in the wrong section but cant find how to delete it. Anyway i have a well mb4402 (tm clone) with a feeding issue when trying to use bbs over .25g. When i am pushing the bolt forward the bb gets jammed about 3/4 the way through what i am assuming is the loading ramp. I have replaced the ramp with a genuine TM ramp and replaced the loading plate with the airsoftpro alloy version. But still the fault is present. I am using .40g blaster devil bbs. I also have baws .25g which feed fine. Any ideas? I was thinking replacing hop up chamber.

Lately I have had same problems with my madbull 0.40g bbs. I fixed it
with 2 small washers (approx 5mm)

Remove your stock (ofc) than remove front and second front screws on the loading ramp. Insert washers and place screws back where they should be. Job done ;)

Elsa 05-28-2017 07:42 PM

Make sure your mag is in correctly. I had the same problem, and it was my mag jamming to many bbs into it and then a bb blocked the cylinder from going in all the way


Sent from my iPad using Tapatalk


All times are GMT -5. The time now is 09:27 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
SEO by vBSEO ©2011, Crawlability, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.