Airsoft Sniper Forum banner
bore up
1-4 of 4 Results
  1. Wanted
    Hey guys, I am searching for the PDI Bore Up Cylinder rings, because I cant find them online (everywhere out of stock). These are the searched ones: https://www.fire-support.co.uk/product/pdi-bore-up-cylinder-ring-for-marui-vsr-10 If anybody has these, I would buy them :) Greetings from...
  2. VSR Rifles
    Hello, i am running a PDI BoreUp Cylinder with a PDI Hop Up Chamber, but i am unsure which barrel would be the best for this setup. I´ve read that, because of the cylinder volume of the bore up, i should use a inner barrel above 500mm - so i found a PDI 6.08 500mm inner barrel , would that...
  3. VSR Rifles
    Hello , i have a small problem with my TM Vsr-10.... i am running a PDI Bore Up Cylinder with the original TM receiver and my Bolt Pull is not very smooth. I already read that the combination does not fit very well, so I edited the receiver a little bit, but its still not smooth. Then I found...
  4. VSR Rifles
    Hello, I have been looking and researching PDI equipment and has seem to stumble on PDI B↑. As far that i can see, the only difference between them and the non boreup parts are the inner diameter of the parts. such as the cylinder which would give it a higher volume. is this true? i have not...
1-4 of 4 Results
Top