[adrwi]

Hi everyone, im planning to get a jg gspec since i've seen a good offer on a site. I'm planning to replace the cylinder, hop up chamber, piston, trigger etc... but i want to know if is it possible to use a 430mm inner barrel, since I already have a mapleleaf crazy jet, and i dont want to get a new one. Thanks

 

[AccurateDMD]

Yes. You'll need to bore out the end of the outer barrel with a drill.

I run a 430mm on my TM G Spec.

 

[adrwi]

Yes. You'll need to bore out the end of the outer barrel with a drill.

I run a 430mm on my TM G Spec.

Ty, i suppose that the barrel doesn't show when using the silencer, right?

 

[mistermist]

You will have some place for suppression left in the silencer after putting in 430mm inner. As it was said, you will only need to bore out one hole.

 

[1tonne]

A G-Spec can take an inner barrel up to 500mm.

 

[Steveocee]

Silverback also do a lovely set of barrel spacers for the G-SPEC specifically with a 430mm barrel. You get 2 for the "normal" locations and then a 3rd to go in the suppressor.

I've got a set on order and am awaiting delivery currently to see how good they fit.