Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
Hey guys I have an A&K sr25 DMR project. Curent parts I have in it: JBU 6.01 650mm TB (Most likely replacing that), Madbull 3 in 1 hopup, Maple Leaf 80 bucking with flat hop, and steel bushings. The gun has been perfectly shimmed by a buddy. Now I want to put more quality parts in it. What would you guys recommed doing to it now? I am looking for a better trigger response also. Keep in mind the A&K uses the 2.5 gearbox so not all parts are compatible. I also want to pick up the new plug and play burst wizard mosfet, does anyone recommmed this? I am also thinking about a high torque motor with a budget of under $60. My field has no class for DMRs. The fps limit is 400 so I will be leaving full auto on just because it occasionally locks up. Basically I would like to have the best range possible at 400fps and a very reliable gun. Thank for any help guys.
 

·
Registered
Joined
·
1,070 Posts

·
Administrator
Joined
·
6,160 Posts
Please make a research before you post... You'll find all the answers you're looking for much easier and faster!


Wolf
 
1 - 3 of 3 Posts
Top