Airsoft Sniper Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
So i got a AA T11 which i have upgraded.
then i decided to change the bolt handle to AA one. Now when i put the bolt cap back on it seems to pull the cylinder back about 3-4mm thus causing the cylinder head to sit back from the bucking and causing at air leak at this point.
Any ideas
 

·
Super Moderator
Joined
·
3,668 Posts
Make some shims or buy some washers and place them between the bolt handle and cylinder.
 
1 - 3 of 3 Posts
Top