Joined
·
1,384 Posts
Saved this screenshot from a while ago!! (Picture attached)
Posts by Blind Sniper
1 - 3 of 3 Posts
Joined
·
1,384 Posts
For your specs I’d go EdGi. If you meant porting, I’m pretty sure it’s a myth. I don’t believe anything is confirmed as far as benefits. BUT you can get a 360mm ported edgi barrel in stainless if you wish. HOWEVER, it will be pricey. Also, EdGi’s ports start approximately 45mm from the barrels end. So that would essentially make the barrel 45mm shorter volume wise. You will lower your fps with a ported barrel. For a “volume matched” ported barrel in a vsr you’d want 370ish + 45mmish.
Joined
·
1,384 Posts
I agree I think if you start going over 400fps with a .48 it may almost be too sporadic. Not saying you can’t land shots at all or can’t land further shots. But in my opinion, too much power can bring less consistency. Maybe it’s even more power than that but too much power will have an impact on a nice, flat smooth trajectory.
1 - 3 of 3 Posts
