[woogie]

Looking at the WE M4 that I have, you may be able to squeeze that system into the body

 

[Wolfgeorge]

So how are we going on the electronics?
I'm beginning to have more free time and I want to finish some of my projects.

Wolf

 

[woogie]

I have honestly given up on the electronics side of things.

I have a few guys working on some drawings for a totally mechanical build.

 

[Wolfgeorge]

Would you like some photos of the Asahi board??

 

[woogie]

Ok well sorry about the long delay guys.....



But I have gotten more parts for the electronic side of the build. I am going to try and build both the electronic and the mechanical "engine"


I have been doing some testing with the parts that I have, and I am thinking that if I am going to be pushing a high fps out of the rifle, that the aluminum may not be the best option for the build. So when I make my next order for material I am going to get some stainless and make all of the internals out of the stainless. I will also get some more aluminum and try a few different builds and options as well.



So it isn't like I forgot about this, but with college, holidays, my soon to be here child, and a project that I am working on for a few buddies, so I have had a few things I have been working on.

 

[Wolfgeorge]

I was thinking the same about material... I steel internal cylinder it will be better for low ROF/ semi only high fps setups.

Wolf

 

[woogie]

http://www.pneumadyne.com/connector-solenoid-p-1240-l-en.html

Well here is the valve I am thinking I may go with. Now just to order it, and figure out this darn electronics, and I should be good to go!

 

[Wolfgeorge]

Is there a solenoid that can handle bigger pressure?
It would good for higher fps!

Wolf

 

[woogie]

That is what I am looking for right now

I am trying to find a small valve that will hold up to 250 psi or higher

 

[bobgengeskahn]

250? Thats a lot, for most of the builds that I have seen they aren't running more than 150 and getting close to 580/600fps...

 

[woogie]

If I am going to push this thing to the limits, I want a valve that will handle it all and not crap out on me. Especially if I am running the rifle on Co2, I don't want a pressure spike to screw up my valve. So go on the high side and you never have to worry about it.

I figure that you might as well get something that is going to run higher than you need, just to make sure you are covered on all of your bases.

 

[Cheese Man]

250 is more than just pushing the limits, though. I can hit over 800 fps with 150psi on my crimebuster, I would think that 250 PSI would either make it explode, or knock holes in the moon... I know that it won't be that specific design, but still, 250 PSI will do some serious damage to just about anything.

 

[mroverkill]

What length barrel are you running in your Crimebuster? I'm getting around 600 at 140 PSI.

 

[Cheese Man]

509 mm. I did make a new nozzle that is about 10x more efficient, though, that helped a TON.

 

[woogie]

Well I have the order in for my valve!!

 

[Wolfgeorge]

That's great... Post some pics when you receive it.

Wolf

 

[woogie]

Will do man.... I am getting some more material as well.

I may go with the internals as delrin, to make them even smoother