[bembesh]

Hi, so I have the Laylax/Prometheus barrel (6.03, 433mm).
The problem is that it's not VSR cut and I want to use the ML Decepticons buckings for my rifle.
So in the picture below..

..is this how should I modify the barrel? should I also create the "circle" around or will just shaving off the "bridge" do the trick?
Also the stock barrel has a slightly bigger window, should i enlarge the window as well?

Thanks for your advice.

 

[Oddsyns]

It has to be like this.

http://shop.ehobbyasia.com/media/ca...8d6e5fb8d27136e95/A/T/ATAM-B01-024_1_MARK.jpg

No other modifications needed.

 

[bembesh]

Ok, so I need both of these:

+ shaving of the bridge?
also is it a good idea? (trying to modify the barrel, I'm worried that it won't work)
Thanks.

 

[Oddsyns]

I don't really think that the 'dent' is needed. Nor the 'tilt'.
The 'tilt' is needed to be straight if you are going to use Rhops, but it should not influence Mapleleaf.
Also, the 'dent' is not needed also. But be sure to wrap some teflon tape to the Mapleleaf bucking, since they are 1mm shorter than normal buckings.

 

[bembesh]

Ok, thanks for your advice. I will consult it with a guy who modifies barrels today hopefully and see what he thinks.

 

[Shoushen]

If you don't put the "dent" in the barrel, you should probably cut off the end of the bucking that coincides with that dent. But I would also suggest some Teflon tape and maybe some dental floss to help air-seal. You might need the cuts behind the "dent" if you're using the stock hop. If you're using the AA, you won't need it.
I used a file and a drill to put the "dent" in my barrel for my spare parts vsr, it works fine.

 

[Dimitri MdP]

Sell your Promy --> get a Maple Leaf. Problem solved.

Don't wanna be that guy... but really, the ML barrel is <30USD, why even take the risk of damaging the promy?

 

[kazuchan]

not <30$, just little over 30$ a bit ( in case 430mm, is 31$ xD ).
Maple Leaf 6.02 Precision Inner Barrel for VSR-10 Series ( 428mm ) / MLTW-IB-430 | WGC Shop - Airsoft Supplier