Airsoft Sniper Forum banner
1 - 1 of 16 Posts

· Registered
24 Posts
Correct me if I'm wrong, but from the picture it seems you do have a PCS bolt, but you are missing the screw which you adjust the gas flow with.

Read the second post in this thread, it has a picture with the different bolt types which you may find useful.

When I bought my Tanaka M700 the screw in mine was missing too. It's a relatively easy fix, you can buy a screw to fit from a DIY type shop.

The one which fitted mine was an M6 size, which is a British measurement of the screw width. Not sure if it's the same wherever you're from though, best method is trial and error. Just take the half of your bolt which you need to the shop and try the screws for fit. I couldn't find a short enough screw, so I had to cut mine down (Quick job with a hacksaw) and also the head of the screw wouldn't fit through a certain part of the bolt where it narrows. The guy in the shop ground it down for me so it would fit, so again an easy fix...

Hope this helps!
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.