[Dimitri MdP]

So, no I am not wrong, I just failed to list temperatures for the given psi..

If you're listing gases in an apparent order of pressure, use a given pressure for one of them and other for the rest, and list it "below" propane, is obvious that anyone reading the post will interpret propylene as having less pressure than propane.

I seriously think you should chillax, and -if possible- edit the order in your original post so all the gases are shown in the proper order, at the same temperature. it's just a contribution to make your post clearer

 

[Plazmaburn]

Welcome to the internet, where if you disagree with someone and post something constructive, it can be misread as an attack. Poor choices of words on both sides tend to muddy the original intent. Not that I took your post as offense, I may have replied as though I did, but it was not intended that way. (I wanted to get it posted quickly, got interrupted numerous times by dumb things....)

I will clean the OP up once I am home. Did not think about it till you posted. I forgot to fix those.

 

[ManicMechanic]

On the topic of airsoft gasses and external rigs/regs... There have been a plethora of new regulators on the market these past few years, and I'd like to see how they all stack up against each other. Sure, I've seen promo vids on the PSI needle bouncing back and forth when a P* is being shot to show refresh and flow... But has anyone done a scientific comparison to find the best reg for different use cases? How does one even test regulators accurately?
Is there data out there already on this? Is anyone willing to do such testing/has the resources necessary?