Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
69 Posts
A simple way to achieve this, is to leave out the whole selector plate, and solder the contacts together that are located under the selector plate, on the left side of the trigger assembly. This way you will have Semi, while having a functioning Safety aswell. just assemble the gun without the Selector plate and you're done. But don't forget to solder those contacts.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top