[Greendore1]

Airsoft Pro Stainless Steel ROUNDED II Cylinder Head for VSR Sniper Rifles (bullseyecountrysport.co.uk)

Just ordered this for my AA teflon cylinder as the original cylinder head keeps ripping up buckings like they're going out of style, however its saying this doesn't fit a stock TM cylinder, will this be an issue to install on my AA teflon???

 

[SiliconeSword]

Nothing to worry about, the TM cylinder is sort of it's own thing.

Pretty much everybody copied the JG BAR-10 I think, save for a select few, and the AA is a copy of the JG thread I believe.

 

[Sodium]

I don't like that nozzle. I find it doesn't properly go into/engage the bucking, causing poor airseal/inaccuracy.

 

[Greendore1]

Nothing to worry about, the TM cylinder is sort of it's own thing.

Pretty much everybody copied the JG BAR-10 I think, save for a select few, and the AA is a copy of the JG thread I believe.

Good to know, thank you for the reply!

 

[Greendore1]

Nothing to worry about, the TM cylinder is sort of it's own thing.

Pretty much everybody copied the JG BAR-10 I think, save for a select few, and the AA is a copy of the JG thread I believe.

Absolute waste of a purchase. The head fits the cylinder fine but there's no air seal what so ever. I've greased the o-ring of the cylinder head to double check and still no seal. I put my old head back on and what you know, perfect air seal. Is this a ASP issue????

 

[SiliconeSword]

It may be too small in terms of diameter, or it isn't going into your chamber all the way.
You can try adding some tape or super glue to the outside of your bucking above the entrance hole to squish it in and have it seal around the nozzle, but I'd do a test with the hop setup and cylinder head out of your gun to see what's up.

 

[Sodium]

That nozzle is bad. It doesn't seemed designed to fit a normal bucking. The o-ring doesn't even go far enough in. Would def avoid.