Airsoft Sniper Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
66 Posts
Be careful not sand it over 120° or it will slam fire.
I will suggest (as I done) to put a shimmer behind the trigger, in order to shortening(?) the trigger pull.
The M150 airsoftpro's spring is heavily OP, it will provide over 600 fps.
Be careful with it, or it will break your cylinder head.
 

· Registered
Joined
·
56 Posts
There are a few threads already that will show you where to file and what to check.
 

· Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
Be careful not sand it over 120° or it will slam fire.
I will suggest (as I done) to put a shimmer behind the trigger, in order to shortening(?) the trigger pull.
The M150 airsoftpro's spring is heavily OP, it will provide over 600 fps.
Be careful with it, or it will break your cylinder head.
I alredy replaced the whole bolt (cylinder, cylinder head (got one for the hop up chamber)), so maybe it wont break, but, if yes, I hope the the ASPro will replace.
Afterall every part in my rifle is ASPro :)

Will try to file down the piston sear.

Thanks for the tip.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top