Airsoft Sniper Forum banner
1 - 2 of 2 Posts

58 Posts
Discussion Starter · #1 ·
For months I have been thinking of a way to make a front sling point for my ASR and finally thought up this so I can use a RIS mounted sling point. After about 3 hours of work I was able to accomplish this! The extended rail sits at almost the same height as the main rail (+ 1/2mm?). Despite this small difference, optics attach between both rails without any problems.

Materials and tools used:
Rail from the Matrix m870 pump action shotgun from evike
Epoxy putty
Syringe type epoxy
Sand paper
Needle nose pliers


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.