[JauTz]

Hey there,

Bought some spare magazines of TM to my BAR10 and they aren't feeding well,
only the first bb shot's....

Aprecciate any help :tup::tup:
Cheers

JauTz

 

[Bronze]

Hmm... 2 questions...

Are they new mags? And,
Which hopup chamber are you using?

 

[Qwazem]

Perhaps the release thing on the mag isn't being pressed. Does it feed another if u push up on the bottom of the mag with the bolt back?

Sent from my XT1254 using Tapatalk

 

[JauTz]

Hmm... 2 questions...

Are they new mags? And,
Which hopup chamber are you using?

Yes they are brand new ones! Im using TM hop up chamber and nineball rubber.

Perhaps the release thing on the mag isn't being pressed. Does it feed another if u push up on the bottom of the mag with the bolt back?

Sent from my XT1254 using Tapatalk

If i give it a little tap everytime i pull the bolt back it actually feeds... How can i fix it? :nuts:

Thanks for the reply's :tup:

 

[Netzapper]

I just had and fixed this problem, the cause for me was too much tension on the front screw holding the hopup block to the stock. If I tighten that too much, after the first shot, the magazine just slightly unseats itself and the feed gate isn't pushed open. The magazine catch would stick down.

Solution was to loosen it slightly.

 

[Qwazem]

The same thing happens if it's too loose

Sent from my XT1254 using Tapatalk

 

[JauTz]

Ill try it and get some feedback soon !

Thanks for the tip



JauTz