BAR 10 Right Curve Issue

799 Views 2 Replies 2 Participants Last post by CHEEKY MONKEY58, Aug 16, 2020

CHEEKY MONKEY58

Discussion Starter · Aug 16, 2020

Howdy,

I installed an AA hop up chamber and while shooting Novritch .4g bb's it shot straight and true and was awesome, though I didn't do extensive testing with those bb's, but the little bit I did, it performed very well.

Well I opted to try Madbull .4 bb's just to try something new and now I have a right curve issue. I can tilt my rifle to the left just a hair and it shoots straight and true. Could I be having alignment issues with my new chamber? Or do people have bad experiences with mad bull bb's? Any information would be appreciated, thanks!

Save

1 - 3 of 3 Posts

Sodium

· #2 · Aug 16, 2020 (Edited)

No bbs would cause a consistent curve in a certain direction. Bad bbs on a good rifle should make the gun shoot equally sporadically in a cone-shaped fashion. Funnily enough, I'm dealing with the same issue right now. Thread should be the 2nd-4th most recent.

How long was the area of testing the first test vs. the second? I originally set my rifle up but only had a 250ft range to test on so I thought it was perfect. Brought it to a 350ft range and found that after about 250ft the shots curve violently to the right.

Save

CHEEKY MONKEY58

Discussion Starter · #3 · Aug 16, 2020

Sodium said:
No bbs would cause a consistent curve in a certain direction. Bad bbs on a good rifle should make the gun shoot equally sporadically in a cone-shaped fashion. Funnily enough, I'm dealing with the same issue right now. Thread should be the 2nd-4th most recent.

How long was the area of testing the first test vs. the second? I originally set my rifle up but only had a 250ft range to test on so I thought it was perfect. Brought it to a 350ft range and found that after about 250ft the shots curve violently to the right.

Yeah that's a good point, I have about 400ft so plenty of distance. Far enough to where my bbs start to naturally drop. I may try re aligning my barrel in my hip up chamber. I was advised after the installation that tightening the grub screws that secure the barrel evenly is really important and I really didn't pay attention during installation so we'll see how that goes

Save

Reactions: 1

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month