[dominik549]

At the end off the barrel of my vsr10 g-spec i tapped 4 holes separated by 90° and put in some set screws after that I enlarged the hole of the silencer and the outer barrel so i had some wiggle room and *PUF* now I can perfectly center any barrel with any bucking if it flies a little to the left, right, up or down and soo far it has proven pretty useful more useful than barrel spacers actually i threw them out after making this mod. I can post a few photos if anyone is interested.
This is the only mod that made my shoots consistent always if there is no wind OFC.
I have also made myself a ring that I can put into the barrel to make the hole smaller again.

reasons to do this:
barrel bent a little bit or shoots to the x or y axis too much.
buckings not consistent.
after installing spacer gun still inconsistent.

 

[lorem]

putting a spacer right at the end would do the same, you also have some screws to put in the aac spacers i think, those can correct bent barrels if I'm not mistaken

 

[SiliconeSword]

Awesome idea, wish I'd thought of that lol.
Definitely interested in some pictures!!!!!

 

[BlackDogAirsoft]

This sounds pretty similar to an lrb mod except it moves it in various directions.

 

[SiliconeSword]

This sounds pretty similar to an lrb mod except it moves it in various directions.

LRB but actually very beneficial

 

[dominik549]

here are the pictures, i didn't paint it so its all in silver aluminium still.
I have done a couple of tests and with a few barrels (one was bent) and managed to center all of them pretty fast
(also this is pretty useful for people with cheap scopes who can go only so far in a desired axis)