Barrel Dimensions help

1580 Views 8 Replies 5 Participants Last post by fuzzywolly, Sep 25, 2011

mrdmr

Discussion Starter · Sep 24, 2011

I am doing to be getting a prommy barrel to go into a PDI chamber on a well mb05. My question is will a 500mm barrel fit in it without sticking out? Also if it doesn't than I can either get a 455mm 6.03 for 75, or a 420mm 6.03 for 60. I don't think the extra 35mm of barrel for 15 dollars is worth it. Help me out here.

Save

1 - 3 of 9 Posts

fuzzywolly

· #3 · Sep 25, 2011

I doubt the 500mm barrel will work most likely because most 500mm barrels are m14 barrels. M14 hop up chambers have different cut barrels which are not compatible with other AEGs.

So no, the 500mm barrel will not work. I've only seen 500mm barrels for m14s. If you can find a standard AEG barrel that length, than go for it.

Save

fuzzywolly

· #7 · Sep 25, 2011

There are various 500mm length barrels for the m14. Many people make the common mistake in ordering a 500mm m14 cut barrel for their PDI/HP hop ups in their l96 variants due to the close proximity between the 499mm l96 length and 500mm m14 length...

Save

fuzzywolly

· #9 · Sep 25, 2011

Cheese Man said:
By the way, just being nitpicky here, but Type 96 barrels are 495 mm long, not 499.

Mine was 499mm. Measured and cut my AEG barrel to the exact measurement.

Save

1 - 3 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month