Barrel problem on m200

Bumping due to no replys

Post some pics to see what you're talking about.
If it's bend at least on the outer barrel you can't do much. You can find a Deep Fire 800mm to replace the stock.

Wolf

I have an M200, if BOTH barrels are bent to the left then theres not much you can do other than buy replacements which will most likely be pretty costly.. Other than that, if its a new gun then get it done on your warranty if you can. Do you know how it managed to become bent in the first place?

Zero

Its gets bent due to time and wear.

And sorry for my latest incident with my comments.

Bumping again.

Can I replace the barrel with the beta project M200?

Probably .... They look the same.

I got the barrel fixed, now to start gettng the a co2 rig attached to the darn monster, any ideas? you said drill a hole into the magazine, but I never done this before, so any ideas?

You should be able to find a guide over on ASF on how to do it.


It actually very easy to do. Just make sure you have everything planned out before hand, and you should be good to go.

Here's the link
http://www.airsoftforum.com/board/Constructing-Air-Rig-56-t127562.html

Wolf