[w4r10ck]

I own a Tanaka AICS, and when I tilt the barrel towards the ground, the bb will just fall out. Is there anyway to easily fix this?

 

[solarisjock]

i had this in my G&G L96, my barrel had rotated inside my hop up so it did not have the bump to retain the bb's

 

[Wolfgeorge]

Check your hop up... As Solarisjock said it very easy the barrel to rotate of the allen screw is not tight enough( beware not too much or it will dent the inner barrel!)


Wolf

 

[w4r10ck]

Alright, is there a disassembly guide anywhere that would help me get the the hop up to check it?

 

[w4r10ck]

Double post, but problem solved, I took apart the hop up and then just put it back together and problem solved. However the set screw was not where it should've been. There was nothing there. So it looks like it's time for a new hopup kit, probably the King Arms one.

Now, I have noticed another problem. The part highlighted in red below has broken and to each side of the problem area is a different piece. Basically the frame is in two pieces. Is this normal or has it been broken? Also, is a little JB Weld okay to lock the two back together?

 

[Wolfgeorge]

Keep in mind that the KA vsr kit needs and a 554mm vsr barrel and vsr bucking.

If I remember correctly the stock frame is one piece.


Wolf

 

[w4r10ck]

Alright. As for the KA kit, is the only reasonably priced 554mm barrel a PDI 6.01?

 

[Cheese Man]

I think the frame on all tanakas is able to be disassembled into 3 pieces, and I think that is where it can be taken down. I can't quite tell by the picture (not enough detail), but it looks fine.