Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
Hi everybody thanks for your time :)

For just 1 year I've used a striker and I love it at the end I bring it to rise 0.40g to 80 meters at 1j (0.99J)

But now it's time to say good bye and go with something more serious... I want a DMR...

Any good advice for start a budget and good DMR? I was thinking to a SR25 or a AUG because my priorities are not the full auto but a distance precision but most important quitest... I'm open to any suggestion thanks in advice.
 

·
Registered
Joined
·
217 Posts
I would say SR-25, it has elongated cylinder which means more air and more power. If you're planning to take AUG because of bullpup configuration then by all means.
But if you are looking for 1J limit then I guess elongated cylinder doesn't matter, or if you want to use wide bore like Magnus 6,23mm.

So other than that, it's back to your preference then. About precision and silent operation, it's all up to internal setting so if you have a good set up then it's done. Make sure you shims your gear perfectly and take shim sets which has 0,15mm shim, allowing you to get more precise shimming. Use correct grease and polished bearings for smooth operation of the gear, and put a proven barrel on it.

Now that I think about it, try Cyma SVU. It is quite pricey but it has excellent hop up unit design which uses TDC so it has really consistent accuracy. It also has elongated cylinder like SR-25 so it doesn't have any problem using even 0,4g bbs. It is also a bullpup which seems to be your liking. The downside is the gearbox assembly pretty much all proprietary
 

·
Registered
Joined
·
399 Posts
An AUG can be made to be stupid quiet, ask @1tonne for that. A P90 can be built in a similar manner.

Otherwise a basic M4 with a good hop up and a well tuned gearbox will do.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top