Airsoft Sniper Forum banner

BASR or DMR

  • Bolt Action Rifle

    Votes: 31 50.0%
  • Designated Marksman Rifle

    Votes: 11 17.7%
  • Both

    Votes: 18 29.0%
  • I'm a spotter, I use a standard AEG.

    Votes: 2 3.2%
1 - 2 of 2 Posts

·
Registered
Joined
·
65 Posts
I love BASR, both how they lok and how they feel. But where i generally play here in Sweden, the others with regular AEGs have about the same range but higher ROF so the BASR is not so much better.

I personally use DMRs. M14 DMR or my G36 DMR. None of which are perfect yet, but they're gonna be sorted ASAP.
 

·
Registered
Joined
·
65 Posts
@Bushmaster_Recon

We don't get around the noise fully. But some methods to reduce noise is possible to do.
I am using a mock suppressor that actually suppress the noise that can be heard. The GB-noise is not as bad as the noise from the barrel, at least not ata distance and if the GB is shimmed properly.

The biggest source of noise in any DMR i've seen, is the noise from the barrel. That smatttering noise the rifle does when the BB is pushed through the barrel. I reduce this with my suppressor which i have filled with a sheet burlap rolled around an old AEG-spring. It works perfectly and the noise is reduced to almost nothing. Or it's just the pitch of the noise that is altered and thus doesn't travel as far, i don't know exactly. But it works.

The most noise my DMR does is in the GB itself. As long as you don't run your setup with a metal pistonhead against a metal cylinderhead, you shouldn't have so much clanging noise. This noise can however be reduced by using the method in the "Holy Grail of DMR"-thread with mouspad-patches on both sides.
But i have found that most enemies don't react at all to the noise that my GB does. The noise we hear from our GB is most comonly only heard by ourselves. At least in my experience.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top