Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
107 Posts
Well cause CA m24 series is extremely close to Maruzen aps-2 series I think I know what the problem is. The slot, where the pin what holds the spring-guide ,does not take the full force when the bolt is closed. What I mean is that the cylinder back part, where that pin goes, touches the spring guide at the end and moves the spring guide forward when you close the bolt.

I hope this picture will explain what I'm trying to say
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top