Airsoft Sniper Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
5,705 Posts
If you are aiming for the highest possible energy, then normally a piston weight of 25-30gm is about right in an AEG.
 

· Registered
Joined
·
5,705 Posts
You can still joule creep massively with an AEG. But it will put extreme stress on your entire GB if you do this.
 

· Registered
Joined
·
5,705 Posts
The main reason most people add a little weight is if the piston is too light, it can bounce on a cushion of air at the end of its cycle. Adding weight gives it more momentum to push through that layer of air.
 

· Registered
Joined
·
5,705 Posts
Not sure. It can be very hard to tell. Really it is trial and error. But chances are, you are pretty close to optimal weight just going off your joule level
 
1 - 5 of 5 Posts
Top