Airsoft Sniper Forum banner

barrel

  • buy a new one

    Votes: 0 0.0%
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hi. Should I rind down the bridge on my lambda ONE 6,01 303mm barrel for my g spec. I recently bought an action army hop up unit, and did a rookie mistake by buying a barrel with bridge. So what's better buy a new one or grind the actual one? (In my country its had to get a 303mm barrel under 120$.)
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #5 ·
I’d run a pdi w hold or something else like mentioned above. If you’re hell bent on the MRhop, I think users have found it best to have a wider barrel window and even wider hop window like a stock chamber, maple leaf or gray AA chamber, etc. I know a guy who widened the red chamber window too.

Anyway, if you want to run a maple leaf Autobot, then I would remove the bridge if you have confidence that you can do it carefully. I would not remove it for MRhop, that’s just me.
So my options are:
1. Buying a W hold from pdi that will work without grinding the barrel bridge
2. Grind the bridge and install an autobot bucking
 
1 - 3 of 3 Posts
Top