Airsoft Sniper Forum banner
1 - 13 of 13 Posts

·
Premium Member
Joined
·
2,311 Posts
Discussion Starter · #1 ·
I need some dimensions from a VSR in order to finish a project I have been working on for CMI.

I need the dimensions of the hop block and trigger guard, how far the hop opening is from the trigger guard, and where the screws are on a VSR. It would be absurdly helpful (and you would earn yourself a 25% discount!) if you took a picture of the bottom of your VSR and edited in lengths, distances, etc. or even just had a detailed technical drawing that I can use for modeling. That means dimensions in all three dimensions of everything below the barrel/receiver.

Measurements are fine too!
 

·
Registered
Joined
·
1,033 Posts
I need some dimensions from a VSR in order to finish a project I have been working on for CMI.

I need the dimensions of the hop block and trigger guard, how far the hop opening is from the trigger guard, and where the screws are on a VSR. It would be absurdly helpful (and you would earn yourself a 25% discount!) if you took a picture of the bottom of your VSR and edited in lengths, distances, etc. or even just had a detailed technical drawing that I can use for modeling. That means dimensions in all three dimensions of everything below the barrel/receiver.

Measurements are fine too!
Ill do it tomorrow, what unit do you went them in?
 

·
Registered
Joined
·
239 Posts
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top