Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,909 Posts
Discussion Starter · #1 ·
Here's my new bolt handle, machined out of brass, Delrin, and aluminum and soldered, epoxied and press fit together.
19049

19048

19050
19051
19052
19053


And here's the old bolt handle and end cap.
19054
19055
19056


The old one was too long and a little thin, but my new one is about perfect as it looks cooler, doesn't snag on things as much, and is more comfortable.
Interestingly I gained +2 FPS and better FPS consistency after changing the handle and end cap, so I assume that the handle is more consistent and secure than the other one.
I also didn't give the handle and cap a spring loaded pin or ball and corresponding dents like my last one, so the lifting and dropping action are very smooth and solid.
 
1 - 4 of 4 Posts
Top