Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
171 Posts
Be careful not to over tighten the spring , I used the same bolt idea and one spring became twisted
But the way you have it works well
Since I need to wait for the initial break-in period before cutting my new spring and I don't have an extra cylinder to leave it in for a few weeks, I just made a little setup out of threaded bar, a couple of lock nuts, and a couple of washers. This should simulate leaving the spring in the cylinder except without needing an extra cylinder. You can get this stuff from your local hardware store for under 5 USD (mine was $2.80). I used 5/16 in. threaded bar and I would definitely recommend not going any larger than that. I hope this helps anyone in the same situation as me :tup:
 
1 - 1 of 1 Posts
Top