[becklr1]

One thing that I keep going back and forth on is the idea of how the BB should be loaded into the "chamber"

because it allows pressure to build up before firing the BB

Think about if you had a blow gun............

Ahh, someone has really been thinking I see. Rethinking even. Interesting...... I'll watch and see how this unfolds. Now, if only this could be applied with a spring gun.

What is the specific problem you are trying to solve? Do you have a problem statement. Perhaps that would help people focus the scope?

 

[becklr1]

Just read the whole post. Not that I am any kind of expert or anything, but I see some legitimate concepts here. From all you. What do you have 3 way phone conversations and brain storm together or something?


Again not that I am an expert on know anything, but I like how you guys are thinking about this.

 

[becklr1]

What about a bucking but that went into the barrel and held the BB snug? Like awagg said a wider barrel maybe and an inserted bucking could be snug allowing pressure to build like bobgengeskahn mentions? The you could do longer or harder bucking and maybe introduce a long hop up not a speed bump type? Just putting ideas out there, not sure if any of it helps.

Interesting reading here. Airsoft folk tend to be enamored with tapering cylinder cap backsides. This talks about port sizes, but yes you will have to apply it to AS but still good material.

http://www.pyramydair.com/blog/2008/10/air-transfer-port-part-1.html
http://www.pyramydair.com/blog/2008/10/air-transfer-port-part-2.html

 

[becklr1]

Anything happening here? any new ideas.

I have never seen classic airsoft as you mention, if you have a schematic can you post it?

 

[becklr1]

Anything happening here? Any new ideas?

I have never seen classic airsoft as you mention, if you have a schematic can you post it?

 

[becklr1]

Notice a stepped air transfer port the cylinder is better than a funnel shaped one that is popular in airsoft.

As far as what you are saying, it very well could be and pretty easy to fab up.

 

[becklr1]

Tubing you mean? Give me eye ball dimensions. Inside, outside and length.

 

[becklr1]

Simple vacuum hose from auto parts store. If you pout it in a chamber smaller than the OD it squeezes the ID down. different auto parts stores have different tubing. You may have to check a few different chains. you can also get it in different thickness.