Compatible replacement stock for the M700 AICS?

6854 Views 20 Replies 7 Participants Last post by Wolfgeorge, May 28, 2011

toomanybbs

Discussion Starter · Apr 20, 2011

I had personally found that crawling on my stomach with the original tanaka m700 aics stock cumbersome. Does anyone know if a stock like this: http://www.24hourcampfire.com/ubbthreads/ubbthreads.php/ubb/showflat/Number/4831188
would work? I have read that it will fit with minor modification. Has anyone tried fitting one? Can it be done with a dremle and sand paper? What would I have to do about the mag release?
Thanks in advance,
Mike

Save

1 - 3 of 21 Posts

hidden187

· #4 · Apr 20, 2011

The only real difference between the m700, m40a1, and acis is the stock its self the bolts and trigger assembly are basically the same. The only difference is the m40a1 has a shorter barrel then the others. What I am doing is taking a stock from a CAm24 and am going to mod it to fit the m700. When I get the stock I will make a how to, but im just waiting to buy it from some one on this site.

Also that stock might work, the hols seam to be in the right spot but I dont know if the metal piece around the trigger on the acis is the same as a m700, but i can look around for you and have a answer shortly.

Ok after some researching i found out that the upper assembly can be swapped only with a whole m24/m40 stock because of this piece.(in the yellow box)

You would need one like this to fit a m24/m40 style stock.(Again in yellow)

Hope this helped

See less See more

Save

hidden187

· #6 · Apr 20, 2011

^^^^Edited above post^^^^

Will delete this when original poster see's the answer.

Save

hidden187

· #11 · May 14, 2011

hidden187 said:
The only real difference between the m700, m40a1, and acis is the stock its self the bolts and trigger assembly are basically the same. The only difference is the m40a1 has a shorter barrel then the others. What I am doing is taking a stock from a CAm24 and am going to mod it to fit the m700. When I get the stock I will make a how to, but im just waiting to buy it from some one on this site.

Also that stock might work, the hols seam to be in the right spot but I dont know if the metal piece around the trigger on the acis is the same as a m700, but i can look around for you and have a answer shortly.

Ok after some researching i found out that the upper assembly can be swapped only with a whole m24/m40 stock because of this piece.(in the yellow box)

You would need one like this to fit a m24/m40 style stock.(Again in yellow)

Hope this helped

Like I said before as long as you have the part in the yellow box then you are good to go. No mod's needed the upper receiver meaning the bolt, and trigger box are the same on the m700, m40, m24. so you can change them if you get a boneyard with that part that is in the yellow box.

Save

1 - 3 of 21 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month