Airsoft Sniper Forum banner
1 - 6 of 6 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
So my cqb boltie is now almost finished! With big thanks to Thirteen Gunworks, EdGI Custom Works, Taring Carving, Double Tap Designs and Springer Custom Works
Internally sporting the following parts:
custom edgi 170mm 5.98 barrel
Action army hop
Aip bucking
Pdi palsonite cylinder
Edgi piston Edgi spring guide
Laylax 100 spring
Springer custom works s-trigger (v7)
And a dtd small feed tube And
Well mb02 with the outer barrel shortened and rethreaded by 13 gunworks
A taring carvings ace stock customised with rails and a stanag magwell.
c&c welcome. will do a shooting test vid and will get some better pics when she's 100% finished. still waiting on the last internal part to arrive and a few external extras as well


· Registered
5,711 Posts
I do like a lot. How much did it cost you all up?
Also, pics with a scope?
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.