Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #3 ·
I've been to that website already and searched everywhere else on the web but haven't found any information about my difficult piece,lol. Thanks

Here are the pictures hope someone can help me.

This is the head, the tip is broken off. If you notice there is no hole that I can place a little allen wrench to unscrew it.


This is a picture showing the crimping, if you notice right below the cylinder head there is a little indention.

Another close up pic of the indention. There is no pin hole around the cylinder head that I can drill out either.


There it is, can anyone help me in my quest to upgrade my gun. How do I take off this cylinder head with no hole for a pin and no hole on the side to drill out.
Thanks you for your guys time.
 

·
Registered
Joined
·
17 Posts
Discussion Starter · #7 ·
thanks for all the help, should I go aout getting a new cylinder set for this or just play with my L96 that works. I've read all over that the VSR is really easy upgrade parts wise, does the same thing go for the L96?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top