Airsoft Sniper Forum banner
1 - 3 of 3 Posts

Registered
Joined
8 Posts
Discussion Starter · #1 ·
Hello everyone.
What is the best way to find out what cylinder and bolt is compatible with a Specna Arms SA-S03?
As far as I'm aware the only things in the rifle that aren't compatible with the VSR10 are the Cylinder Head, Hop Up Chamber and Magazine. But I tried a Novritsch SSG10 bolt and it was too small to fit on to the end of the cylinder. I thought that the SSG10 was also VSR10 compatible too which is why I am now here. Help me please, before I spend hundreds of pounds on trial and error.
Thanks 馃檹
 

Registered
Joined
378 Posts
If the difference isn't significant, maybe you could file down the bolt hole little by little until the bolt fits snugly into the cylinder tail. Although I would prefer to file down the cylinder tail so that it will fit more aftermarket VSR handles. Or if you don't need it to be very precise fit, use dremel so that it will be quicker.
 

Registered
Joined
8 Posts
Discussion Starter · #3 ·
Thanks for the quick response. Doing something like you've suggested is still plan B for now. I'm going to try a PSS10 Left Hand Bolt after reading the the SSG10 isn't quite 100% compatible like advertised. If the PSS10 Handle doesn't work then it'll be a custom job I think. If it's any help to anybody reading I believe the bolt handle that is currently on the rifle in the Tokyo Mauri Pro Bolt Handle. It looks very similar anyway. 馃憤馃憤
 
1 - 3 of 3 Posts
Top