Airsoft Sniper Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
297 Posts
Discussion Starter · #1 ·
I have started realizing that in my javelin m24 the bolt handle and the part the bolt handle screws into the gun is starting to separate. I am using a brand new cylinder I had bought last week. This started happening with my old cylinder and it had eventually snapped in half. Does anyone know of any ways to prevent this from happening? Should I just invest in a PDI Raven cylinder?
 

·
Registered
Joined
·
228 Posts
I put the superglue onto the seam where the pot metal and cylinder joins. I place a tiny drop all the way around and you can see it seep in very quickly.

It will bond the handle stud to the cylinder permanantly.

I have done this all my cylinders including my new VF C ASW338LM.

PDI welds theirs.
 

·
Registered
Joined
·
234 Posts
The PDI cylinders are solid! I have the non-palsonite version on my CA M24 and it is solid! It uses the stock cylinder parts from my M24 with no problems.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top