Airsoft Sniper Forum banner
1 - 20 of 30 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
Hi, after installing the airsoftpro Gen 3 hop up unit. A BB Stucks between nozzle and barrel every reload.

I use black modify bucking an R Hop AEG Posaidon Air cushion 500mm 6.05


Any suggestions?
19366
 

·
Registered
Joined
·
142 Posts
Maybe the hop chamber has not been properly installed, maybe misaligned? Try disassembling the rifle and putting it back together.
 

·
Registered
Joined
·
2,126 Posts
I would suggest disassembling your rifle and looking for two little screws on your hop chamber that are above the BB stoppers.
Once you locate them, unscrew them until you can barely reinstall your hop chamber and try that.
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #4 ·
19373


U mean that @siliconsword?
I dissasambled all and build it together again. Nothing helps.

Sometimes I get double feed also.
 

·
Super Moderator
Joined
·
3,854 Posts
Does the bb stick half way into the chamber?
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #15 ·
19396

So I hope this will solve the problem I have to change the piston to because the steel nozzle won't fit on the blue tuning piston 550fps what I use bevore.
 

·
Registered
Joined
·
92 Posts
The AEG adapter goes on the end of the hop rubber and is put inside the hop up unit with the barrel/hop rubber you would need to remove the barrel to check
 
1 - 20 of 30 Posts
Top