[justbeagamer]

After hours of work, my Spr finally has consistent fps output, a good rhop, but wont feed well!!
The problem can be solved by pushing/pulling the mag intop a certain position, I have tried "shimming" the mags with electrical tape without success.
I am using dBoys midcaps
Anyone have any solutions to this problem?
Would it be wise to buy an entirely new body from a good brand like G&P?

 

[CrusherW9]

Make sure you hopup chamber is in the correct position.

 

[justbeagamer]

Its all alligned, bought some pmags and gonna try later

 

[justbeagamer]

Just to let anyone who has the same problem as me. (The magazine bb release not being engaged by the hop up)
All I did was replace my hopup with the modify metal chamber, that aparently has a feed tube 0.5mm longer than normal hops.
Hope this helps