Airsoft Sniper Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #3 ·
Thanks! Painting was a lot easier than I thought. The scope is rubber, so I can't paint it, but I do have a burlap/veg wrap that I can throw on there.

It shoots kinda funky. I tried .28's at my last target, wasn't impressed. It seemed more consistent stock with .40's. I'm going to tear the hopup down again, redo my teflon, and add shims to the arm. Based on other reports, that should take care of it.
 

·
Registered
Joined
·
2 Posts
I am looking to get the echo 1 m28 and a bag for it. i have not been able to find the length of the rifle anywhere =P so i dont know what bag to get. if you or anyone else could tell me that would be great. and by the way the paint job looks awsome.
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #7 ·
helldragon300 said:
I am looking to get the echo 1 m28 and a bag for it. i have not been able to find the length of the rifle anywhere =P so i dont know what bag to get. if you or anyone else could tell me that would be great. and by the way the paint job looks awsome.
4.5ex

The solution can be found in the introduction section.
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #10 ·
Update!

After a hiatus, from airsoft and this board (3 weeks left until I get my B.S. in Business), the gun now shoots birdhouses at 100 ft (headshots ftw) and a 12"x36" board at 200 ft with 90% or better consistency.



Working on my new ghillie.
 

·
Premium Member
Joined
·
3,494 Posts
Great news man. Been awhile since there was an update, but were you having accuracy problems with the rifle before? I know someone on here was having trouble with their m28 clone, but forgot who.

If so, any update as to how you got her working smooth? I know quite a few guys would benefit from this.
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #12 ·
fuzzywolly said:
Great news man. Been awhile since there was an update, but were you having accuracy problems with the rifle before? I know someone on here was having trouble with their m28 clone, but forgot who.

If so, any update as to how you got her working smooth? I know quite a few guys would benefit from this.
It was a hop up shim mod that used index cards (yours?), and Dragon64's teflon tape guide. And I lubed the crap out of the internals with white lithium grease.

With .36's.

And then I worked on getting the scope set correctly.

Oh, I also hit a board at 300 ft on the first shot. It was the size of a small car, or a gaggle of newbs.

If your friends are having mechanical problems, I can't really offer any insight. I haven't had any so far. maybe I'm lucky, or I just don't shoot that much.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top