Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey folks,

Looking to build a DMR for the first time as a way of practicing. The base model I am using is an old Echo1 Stag Arms M16: http://www.airsoftmegastore.com/953...15-m16a3-dmr-airsoft-aeg-rifle-jag-jp-14.aspx

Specs are as listed:

- 11.5-inch full metal quad rail
- M120 spring w/ metal spring guide
- 21-inch metal outer barrel
- Inner Barrel: 509 mm
- Muzzle Velocity: 400-420 FPS (w/ 0.20g BBs)
- Gearbox: Full Metal Version 2
- Battery: 8.4V 1500 mAh Large Type

Images to the stripped gun here:
My questions are the following:

1. Will any M4/M16 outer barrel fit into the upper receiver? The stock outer barrel has the iron sights molded on so I am looking to replace it. Minimal wobble would be best.

2. What hop-up/bucking would you recommend for this gun? I haven't been able to find any builds around this gun so I want to make sure I purchase a unit that fits properly.

3. Any recommendations for the gearbox? I think the M120 spring and metal spring guide should be fine, but should I do anything about the trigger?

4. What length rail system would you recommend for the recommended outer barrel?

Thank you all for your help!
 
1 - 1 of 1 Posts
Top