Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
354 Posts
Discussion Starter · #1 ·
Hi!, i think to buy the new echo1 m28 kit, it's made of aluminum: the piston and the spring guide, but is in 45 degrees, you believe that if I modify the piston in a lathe to a 90 degree, it works well? Or will I just ruin it? Or it has to be a steel 90 degree end piston?
 

·
Registered
Joined
·
23 Posts
I'd say it depends on the shape and material of the piston, If it's good quality and it remains thick enough after the modification, there should be no problem .. I modified my EdGi piston to 90° and so far it seems to work fine .. it's only been recently though, so I have to test it more before I can say for sure that it works. imgur link
 
1 - 3 of 3 Posts
Top