Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
745 Posts
Discussion Starter · #1 ·
Been thinking about possibly changing my tightbore (Edgi 6.01mm) to a longer, not as tight PDI/Prom. I'm using a 455mm currently, and was thinking a 509mm Tightbore (PDI/Prom) with my silencer off my M14.
I'm having a extremely hard time finding a barrel by PDI that'd fit. Not sure how to approach this at all. I'd be getting Laylax Spring Guide, Piston, and Spring with this aswell. I'm trying to get some seriously nice internals started in my sniper, using kind of cheap parts at the moment


Would any like to suggest to this?
 

·
Registered
Joined
·
445 Posts
All of PDI's aeg barrels http://www.x-fire.org/etop/05.html, they only have .04 if you get the 10mm outer diameter. Save some green and get a edgi again, I have had a PDI and a EDGI the difference between the two are small if any in accuracy, the only real difference is EDGI is brass and PDI is steal.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top