Airsoft Sniper Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
3,975 Posts
It is just a bar10 with a gas cylinder in it. Not that hard to see it shooting 650 fps, I mean you should be able to get it up much higher than that.

Just another gimmic, though could be a fun project rifle as well.
 

·
Registered
Joined
·
205 Posts
It's the same idea as the SVD version.
The CO2 cartridge goes inside the bolt (It's a two piece cylinder that screws apart in the middle).
There are vids on youtube for versions of this gun (Swiss Arms SAR10 I think).
It's said to be inconsistant and dangerous...
I would stay well away from it.
 

·
Registered
Joined
·
83 Posts
I have been looking at this gun too, I was thinking if it would be possible to decrease the fps a little with a different valve? also a new barrel and hop-up could make this gun pretty good I suppose. Ofcourse with Great power comes a great responsibility ;p
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top