For those of us less fortunate...

1150 Views 6 Replies 6 Participants Last post by hoggie, Jan 9, 2012

bobgengeskahn

Discussion Starter · Jan 7, 2012

I found this for those of us that might have ideas but not the means in one form or another. They do custom fab, only down side is you have to write in their program, so there is a little more guess work involved vs. using solidworks where you can simulate and plug in standard parts.

http://www.emachineshop.com/

Save

1 - 1 of 7 Posts

goldentrigun

· #4 · Jan 8, 2012

The reason it can get so pricey is because of the tooling. For example a single end mill bit costs anywhere from 10USD to 150USD or even more and most (if not all) of that cost will come out of your pocket.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.