For those of us less fortunate...

1153 Views 6 Replies 6 Participants Last post by hoggie, Jan 9, 2012

bobgengeskahn

Discussion Starter · Jan 7, 2012

I found this for those of us that might have ideas but not the means in one form or another. They do custom fab, only down side is you have to write in their program, so there is a little more guess work involved vs. using solidworks where you can simulate and plug in standard parts.

http://www.emachineshop.com/

Save

1 - 1 of 7 Posts

woogie

· #5 · Jan 8, 2012

Trigun nailed it.

The tooling and the machines itself can get really costly.

What parts were you wanting made? There are a few of us on here that have said tooling, and are usually more than willing to help out.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.