Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
807 Posts
Discussion Starter · #1 ·
I found this for those of us that might have ideas but not the means in one form or another. They do custom fab, only down side is you have to write in their program, so there is a little more guess work involved vs. using solidworks where you can simulate and plug in standard parts.

http://www.emachineshop.com/
 

·
Registered
Joined
·
807 Posts
Discussion Starter · #3 ·
Yeah, their prices didn't seem too bad. I know most of the local shops around me can get a little pricy, mainly because their time for walk in projects is pretty scarce.

I tend to use a lot of scratch paper and napkins... there are piles of ripped up paper in my place, if nothing else it drives the woman crazy
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top