Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I just recently purchased a G&G M14 and the wolverine kit from amped-airsoft to convert it to a HPA system. My question is is that I want to shorten the barrel a bit since it is a standard size M14, mainly to eventually accommodate a suppressor and not make it so long with the added length. Would my best option be to:
-Find someone/somewhere to cut my outer barrel and re thread it?(is this expensive?)
-Purchase a shorter barrel?(If so, does this one work?)
-Some other option?

Thanks for your time.
 

·
Registered
Joined
·
942 Posts
I will place my bets on the linked barrel not working since the Cyma/JG ebr is TM spec. Never actually tried it myself though but I am fairly certain it wouldn't work. You will probably have better luck chopping and threading.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top