Airsoft Sniper Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
570 Posts
Discussion Starter · #1 ·
I'm having a custom barrel made which will use G&G's outer barrel locking nut to connect to the receiver.

I would greatly appreciate someone telling me the threading dimensions (threads per inch, length of threading, etc.)!!!
If I can't figure them out, I'll need to wait to receive the item in the mail before the barrel can be made!
 

·
Registered
Joined
·
570 Posts
Discussion Starter · #3 ·
I mean posting in the Tanaka section itself is pretty much inherently necro-posting :p

No, unfortunately, if you were looking for the same thing. I ended up building a new rifle entirely...
 
1 - 3 of 3 Posts
Top